Secure the nut another quarter turn with an adjustable wrench. Tighten the connector with your hands and wrap the nut with a rag. Take out any previous tape which form the linear grooves on the flexible tubing or shower arm.Ĭover the threads in fresh tape. Ensure you push in the washer with your fingers. Return the filter screen and washer to their original position on the fixture. Remove the restrictor with a flat head screwdriver. Move to the end of the holder, then pull out the washer, and filter screen with needle-nose pliers. Rotate the nut with clockwise movements until the holders drop from the shower arm. Firmly hold the arm with a pipe wrench while you use the adjustable pliers to hold the nut. If you have a product with a restrictor inside the holder, protect the connector and shower arm with a clean rag. Pull out the exposed restrictor with a flat head screwdriver. Pry the washer out of the handle and filter screen with needle-nose pliers. Firmly hold the covered nut with adjustable pliers and rotate counterclockwise to take out the handle from the tubing. If you have a product with its showerhead at the bottom of the handle, protect the connector nut with a clean rag. However, the position of the restrictor depends on its brand. Usually, the water restrictor is found inside the holder attached to the shower arm, or the end of the handle that connects to the flexible tubing. Look for the water restrictor on the handheld showerhead by using the owner’s manual or manufacturer’s website. The tips below will help you take out their water restrictor within minutes. Handheld shower heads are quite popular with homeowners. How to Remove a Flow Restrictor from a Handheld Shower Head Use the adjustable wrench to turn the nut. When the nut is firmly placed, wrap a rag around the nut and arm, then grab the arm with the pipe wrench. Secure the connector nut by tightening it with your hands. Wrap fresh tape around the threads in a clockwise direction. Take out the existing Teflon tape from the linear grooves on the shower arm. Fix the washer and push it with your fingers to prevent it from falling off. Return the screen to its original position. If you don’t know what a restrictor looks like, it’s a plastic disk with any of the following colors such as white, green, pink, and red. Pull out the flow restrictor with a flat-head screwdriver. If the screen is stuck, use the pliers to remove the item. Remove the screen by tapping the bottom of the head with your palms. Gently take out the washer with needle-nose pliers. Normally, both items have to be extracted before you can see the restrictor. Here this item offers a tight seal and secures a mesh filter or screen. Look for the washer inside the connector nut. Loosen until the head is removed from the shower arm. Hold the arm firmly with a pipe wrench and loosen the connector nut with an adjustable wrench. Wrap both parts with a clean rag to protect them from scratches. Locate the bent pipe or shower arm and connector nut that sticks out of your bathroom wall. With these steps, you can handle extract the restrictor with ease. Many homes have this type of shower head.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |